Through the screw cap with sealing ring, the interior is hermetically sealed.
Handcrafted from high quality stainless steel, this pendant is also ideal for allergy sufferers.
The pendant will be delivered together with a matching necklace in an exclusive, original "myGalgo" jewelry case.
Dimensions:
Diameter: 26mm
Heigth: 35mm
Thickness: 6,5mm
Inner diameter eyelet: 4,3mm
Length necklace: 46cm
Weight:
Pendant: 28g
Collier: 4g
Materials:
Pendant: stainless steel 316L, polished
|
|
But before we start, an important note:
We use acrylic-based glue that cures in seconds. When using the adhesive, the corresponding instructions on the adhesive (ventilation, ...) must be observed.
Please note that the orientation of the eyelet for attaching the necklace can no longer be twisted after the adhesive cures within a few seconds.
And: less is more! The adhesive is to prevent later only loosening the screw. The often called "sealing" and "closing" takes over the small rubber seal on the screw. So please use only one drop!
 |
 |
 |
| 1. Remove the screw on the piece of jewelry, which is located in different places depending on the piece of jewelry |
 |
 |
 |
| 2. If possible, use a funnel to fill |
3. The interior may only be filled to 80%! | 4. Less is more: a small drop of glue is enough |
 |
 |
 |
| 5. Bring the drop with the toothpick directly to the internal thread |
6. Turn the screw in quickly! Pay special attention to the alignment of eyelets. A correction is not possible later! Wait approximately 24 hours for the glue to cure completely. |
 |
If something goes wrong:
- Adhesive residues can be removed with acetone solution
- By strong heat, e.g. a hot air gun makes the adhesive liquid again and the screw can be removed or twisted. However, parts (e.g., sealing ring) or the surface of the jewelry may be damaged. Therefore, we do not assume any warranty or liability for incorrectly filled pieces of jewelery or damage arising in connection with the filling.
We are happy to help you if it does not work.
Your
MyGalgo - Team